The stompbox-sized receiver fits right alongside your other pedals, and includes a docking port for charging the transmitter and automatically setting the best wireless connection. There’s even a handy DC output, allowing you to distribute power to multiple pedals on your board.
Once you experience the wireless independence provided by the WL-50, you’ll never go back to using a standard cable again! Setup is quick and simple, and you’re able to move about freely while playing at home, jamming with friends, and performing on stage. During sound check at a gig, you can listen to your tone out front and dial in the best sound for your audience. And with the ability to roam and interact with other musicians, your live shows will be more dynamic and entertaining than ever.
Wireless Format: BOSS proprietary digital audio format
Wireless carrier frequency: 2.4 GHz
Compatible Channels: 14 (May vary due to local conditions)
Transmission Range: 65 feet line-of-sight (May vary due to local conditions)
Latency: 2.3 ms
Dynamic Range: 110 dB or greater
Frequency Response: 20 Hz--20 kHz
Nominal Input Level: -10 dBu
Input Impedance: 1 M ohm
Nominal Output Level: -10 dBu
Output Impedance: 1 k ohm
Recommended Load Impedance: 10 k ohms or greater
Controls: CABLE TONE switch (OFF/SHORT/LONG)
INPUT jack: 1/4-inch phone type
OUTPUT jack: 1/4-inch phone type
TRANSMITTER jack: 1/4-inch TRS phone type
DC IN jack
DC OUT jack
Power Supply: Alkaline battery (AA, LR6) x 2
AC adaptor (sold separately)
During wireless operation: 60 mA
While charging transmitter: 320 mA
Expected battery life under continuous use Alkaline battery (AA, LR6): Approximately 10 hours
* These figures will vary depending on the actual conditions of use.
Leaflet USING THE UNIT SAFELY
Rubber foot x 4
Alkaline battery (AA, LR6) x 2
An AC adaptor (PSA-S series) is required to charge the transmitter (WL-T).
Options (sold separately)
AC adaptor: PSA-S series
Parallel DC cord: PCS-20A (DC Plug x8)